Automatic Tank Gauge

 

In-Station Diagnostics (ISD) – Troubleshooting Collection Alarms & Warnings in CA
Technical Support
June 24, 2022 | Veeder-Root

These instructions are intended to help certified technicians troubleshoot Collection Alarms and Warnings on both Balance and Vac Assist ISD Systems.

Read More
Probe & Sensor Wiring
Technical Support
May 9, 2022 | Veeder-Root

Veeder-Root has specific requirements for all Automatic Tank Gauge (ATG), probe, sensor and Pressurized Line Leak Detection (PLLD) transducer wiring –this is to maintain intrinsic safety as well as reduce electrical noise interference.

Read More
Pre-Wired Cabinets & Intrinsically Safe Wiring
Technical Support
April 14, 2022 | Veeder-Root

Intrinsically safe wiring is a method of protection in which the wires and devices are incapable of creating a spark and igniting fuel. In a Veeder-Root Automatic Tank Gauge (ATG), the low power modules, wiring and devices are considered intrinsically saf

Read More
TLS-450PLUS & TLS4 Series – iButton Obsolescence
Technical Support
April 4, 2022 | Veeder-Root

As of March 2022, iButtons are no longer being used in consoles with software version 10.C or later.

Read More
TLS-450PLUS – Divider Plates
Technical Support
March 24, 2022 | Veeder-Root

The TLS-450PLUS console must be installed per the TLS-450PLUS Site Prep and Installation Manual (577014-073) and the UL/cUL Control Drawing - TLS-450/8600 Consoles (331940-008). The console may not be modified in any way.

Read More
One Year Later with Cumberland Farms
Combat Corrosion
March 25, 2022 | Veeder-Root

We caught up with Cumberland Farms, which is installing HydrX at new and existing sites, to find out how well the solution is combating in-tank corrosion. Twelve months and thousands of gallons of fuel later, the differences are striking.

Read More
Allied Electronics with BIR DIM Applications
Technical Support
November 4, 2021 | Veeder-Root

TLS-450PLUS consoles with Business Inventory Reconciliation (BIR) require the use of a Dispenser Interface Module (DIM).

Read More
TLS4 Series Security Settings
Technical Support
January 20, 2022 | Veeder-Root

The TLS4 Series consoles come with security features allowing for greater protection and control of access to the Automatic Tank Gauge. Features such as configurable user access and segmented network ports help ensure both network and front-panel security

Read More
Optional In-Station Diagnostics Software Upgrade in CA
Technical Support
January 5, 2022 | Veeder-Root

This optional software update to TLS-350 software version 336.02 and ISD Version 1.06 (Balance) or 1.07 (Assist) is due to the expiration of a California Air Resources Board (CARB) provided Onboard Refueling Vapor Recovery (ORVR) Penetration Table that is

Read More
Line Manifold Setup & Programming for the TLS-450PLUS
Technical Support
October 18, 2021 | Veeder-Root

The TLS-450PLUS console can be configured to allow two or more tanks to run on a line manifold system. The console can be programmed for a specific dispense mode, such as alternating (with customizable settings and thresholds).

Read More